Foward and Backward in Digital Mode

[Anonymous]

Acelsodd

if you move the signal from one side of the rails to the other the train will travel in the opposite direction.

signal palcement controls the direction of the train travel in digital mode

Don

[Anonymous]

Hi, Blazer9:

I understand, and in fact, I use the signals placement in the way you describe in you answer, but I decide to put the sign in the “left” side or the “right” side of the track in the very moment that I am BUILDING my rail. And this is a “static” placement.

When I say “static” I mean that the signal CANNOT be changed while I am in “play” mode (just watching the trains “running” in a completely built rail), as in opposition to the behavior of controls, that are just “programed” while BUILDING the rail, but they “execute” their programation while “RUNING” the game.

And that is exactly what I want: imagine a long horizontal piece of track. The engine must start its movement from left to right, then stop before the end of the track and after that, return its way back in the same track from right to left.

So, the question remains.

I apologize for my “medium level” english. If I didn’t make myself understood, please inform. (or even if I didn’t understand your answer) 😳

[Anonymous]

acelsodd wrote:

But, how can I do the same, in digital mode, using only signals?

Place the signal on a short straight so, that the engine runs on the next track piece while it brakes. Then on the next piece you can use another signal to start it in the opposite direction. There is no better way.

brainbom

[Anonymous]

Thanks, ‘brain’, that was exactly what I was looking for!

[Anonymous]

Hi Antonio,

I mainly build layouts in digital mode. I can change direction of trains as brainbom say. And i tested to control speed of trains also in digital mode.

If you let trains with more than 1 loco in front drive over the board you can control speed over distance from signal to the controler for this signal.

If the train has to pass signal with fullspeed then set controler for that signal far 2 trackpieces. If you want the train slow down then set the controler on the 1st trackpiece after the signal 😉

[Author]

Posts