- This topic has 0 replies, 1 voice, and was last updated 17 years, 4 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
This is a technical one. I was putting some power controls in the track and it automatically names them P1, P2, P3 and so on.
Well that’s okay but I put them on the buffer track and I had some of them the wrong way round.
You can not do a 180 deg because of the buffer so I move the power to a small strait track, fine but it numbers it P4 and I wonted P1.
Now I know I can re name it but can I set the count back to 1 someware in a file and start placing power controls again.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.